How to Increase Your Xbox's Fan Speed aka 12v Fan Mod
(v0.1)
Tutorial
written
by : cityson
Last edited:
August 10, 2003
Disclaimer
I will
not hold
responsibility
for anything
that might
happen
to your
Xbox,
opening
it will
void the
manufacturer’s
warranty.
All actions
you followed
in this
tutorial
are done
so at
your own
risk buddy.
Install
Diagram:
Tool
needed:
-Torx
10 Screwdriver.
(To open
the Xbox
case and
unscrew
a screw
on the
mobo.)
Instructions:
-Unplug
power
cord.
-Take
out HDD
+ DVD
drive.
-Unclip
the stock
fan using
a screwdriver...(You
know where
the clips
are...)
-Take
a look
at the
fan’s
plug.
Use a
needle
to pinch
out the
“black”
wire.
-Ground
the “black”
wire under
a screw
on the
mobo.
as shown.
-Leave
the “red”
wire the
way it
is though.
(You see
the “red”
wire’s
always
plugged
in.)
P.S.
MAKE SURE
THE “BLACK”
WIRE’S
TIP IS
TOUCHING
THE “SILVER”
PART UNDER
THE SCREW!
FAIL TO
DO SO
WILL MAKE
YOUR XBOX
“RESTART”
FREQUENTLY
DURING
THE NEXT
BOOTUP!
That’s
all, thank
you for
reading
this.
Hope it
helps.
Tutorial
written
by : cityson
