Tutorial written by : Sk8ermike6789
Last edited: September 20, 2003

Materials Needed:
- 4 simple on/off SPST switches
- Some Wire, 30awg is good, but anything will work.
- Soldering tools and solder skills
- A chameleon mod chip (DUH) any version will work.

Here is a picture showing how to wire up the expansion port for use with external switches.
NOTE THAT BLUE AND RED WIRES NEVER CONNECT

Now, the picture is pretty self explanatory, this is basically what you do...
1. Solder the points labeled "Dip 1","Dip 2","Dip3","Dip 4" on the expansion port
to one side of the corresponding SPST switch.
2. Solder the point labeled "GND" to all the empty sides of the switches.
3. Make sure all of the dip switches on the chameleon are off.
4. Enjoy your new external toggle switches!.

I am not responsible for any damage done to your mod-chip or Xbox for that matter.
as in doing any mod, be very careful.

Thanks go out to Xodus_Chip and the entire Xodus team :)