Tutorial written by : wmz & stanz

- This tutorial is good if you dont want to cut into your IDE cable and HDD power cable!
- Alternatively you can cut into your IDE cable and HDD power cable then Solder where necessary! (check this tutorial)
- You can still easily install / remove the XBOX HDD with the following MOD!

Ingredients Needed . . .

* 5mm LED, Heatshrink
* 220ohm Resistor
* Wire
* Solder Equipment
* Drill and Drill Bits

(All of above available from Maplin, BQ, or wherever is cheapest)

Begin . . .

Solder Green / White Wire Directly onto HDD PCB . . .

Result . . .