Tutorial written by : AKILLAMUTHAFUCCA
Last edited: April 16, 2004

This is a way to connect your x2.3 lite or pro to xbox non solderless and no pin header.
Using the chameleon solderless adaptor yes the chameleon solderless adaptor.
Ok first thing you do open your kit that you bought from system-mods you should see this see x2.3 lite contents

Ok theres a wire there thats grey and black for the ground get that one and solder the grey wire to the do point on the chameleon adaptor solder it directly to the point closest to the d0 point but not too close to side thats going to touch the m/b.Ok now connect all your other wires like usb power adaptor,switch board,get all the wires connected to chip then set your chameleon adaptor down on the m/b if you need to clean your lpc points and two ground points do that before you install the adaptor ok assuming you connected all the other wires and have the ground for usb adaptor connected and all points are clean ok now bend up the ground on that goes to chip its a black wire that you first picked up bend that up so it does not ground those traces that are right on that side of the chip ok put your screw through then tighten down the chameleon adaptor and ground under that line everything up you get it pretty tight and make sure your d0 point is in the right spot ok you should have done this without any problems if you have problems your not following simple directions then put your chip down on top of the solderless adaptor you should be a ok now put everything back together and power up its should boot up and take you to the flach bios srcreen if not the lpc might have filom on them or the do point is not touching or your 2 ground points need to be cleaned

Tutorial written by : AKILLAMUTHAFUCCA