|
Back to the news-page
X3IR Installation and Information
>> Divineo sent us some new info and the installation instructions of the Xecuter(info) X3IR (IR-addon):
[QUOTE]
X3IR Description: Weight: 20g / per piece
Features:
1. Blue status led
2. Compatible with any modchip
3. Enable/Disable Modchip upon boot.
4. Easy to use programming software
5. Learning functionality allows virtually any remote control to be used
6. User programmable buttons for all functions, such as wich button turns on the xbox or turns it off
7. Safety Off (tm) makes sure you press the 'OFF' button 3 times before turning off the xbox to prevent unintended xbox shutdown
8. Turn ON and OFF the XBOX with the XBOX Dvd remote control, and any RCA DVD compatible remote (and there are hundreds of these)
9. Perfect-Press (tm) - The length of emulated press of front panel 'Power' button can be finely tuned to work with any modchips' needs (ie. long press is 100msec - mod on, short press is 10msec - mod off)
X3IR - Installation instruction:
1. Tear off the CR sticker, and stick it on the back side of IR PCB.
2. Remove 2 screws of X3CP as photo.
3. Turn component side of LED PCB up, and stick the IR PCB at the location as photo.
4. Turn around the 3 wires to go backside of LED PCB and screw on the 2 screws as photos.
5. Plug the white cable into the connecter of the Programer, and go through the both white cable and IR cable to the hole of XBOX as photos.
6. Plug 3Pin, 5Pin(Pitch1.0) and 5Pin(Pitch1.25) cables into the X3IR mainboard and 2Pin cable into X3 Reset-Eject board, and then stick mainboard at the location as photos.
7. Install the programer at the bottom of X3CP with CR sticker as the below photo.
[/QUOTE]
See all installation pictures: here
Discuss this news item on our forums: forums.xbox-scene.com
Back to the news-page
| |
|
|
|
|
|
|
