|
Back to the news-page
Xecuter NAND-X Install Pics Part2 – JTAG
>> From team-xecuter.com:
[QUOTE]
We recently showed you how to easily install the NAND-X using the included quicksolder pcb system, now here is an image to show you how easy and clean it is to install the JTAG hack to the 360 motherboard.
For this example we have used the Xenon motherboard. There are a number of features to note:
* All component strategies based on hundreds of user reports
* Tested on all motherboards Xenon, Falcon, Zephyr, Opus & Jasper
* All diodes used will be BAT41 (Maximum compatibility and success)
* Points 4 and 7 on J2D2 has a switchable 330 Ohm resistor (many reports of RROD on certain motherboards without it, and also many reports that it is not required on certain motherboards)
* Option to disable JTAG completely. We have basically added an "OFF" switch for those that need to disable the JTAG hack for whatever reason (testing, debugging, returning to stock etc). This of course saves you the time from having to desolder anything.
* This is the cleanest and most solid JTAG install you will find. No need for any circuits to disable the JTAG after so many seconds - no messy installs or bad parts causing RROD's.
* We are providing 2 x Cables for J2B1 (1 for Xenon and 1 for all other motherboards. Cut to the perfect length for optimum signal)
[/QUOTE]
Full Story/Official Site: team-xecuter.com
Pre-Order NAND-X: mrmodchips
Discuss this news item on our forums: forums.xbox-scene.com
Back to the news-page
| |
|
|
|
|
|
|
